Contactor Professionals Motor starters are devices that regulate the current that goes through the motor. These can be electric, hydraulic, or pneumatic in nature. As its name suggests, it helps motors to properly start or stop. This happens when the device regulates the flow of current towards the motor.
The History of The Starter Before the starter as it is known today was invented, many different methods were used to start the engine in vehicles. Early methods involved the use of gun powders to pump the cylinders. The other method used wind up springs. People also used cranks to start the engines. Airplanes and other similar vehicles were able to start using cranks.
The very first method that was used to start vehicle engines was the hand crank. But as time went by, people found cranks to be inconvenient and sometimes dangerous. First generation engines were hard to pull. It would take a lot of might just to crank the engines. An engine has the ability to kick back, and this causes it to create a reversal movement.
Other motors were equipped with slips. This allowed users to release the starter once the engine successfully starts. However, if the engine decided to kickback, the starter would still be attached to the engine while it was starting. This caused shaking and jerking which caused some injuries in the past. mag-trol.com/
The Different Types Of Starters
Today, modern starters are used in most vehicles and these are the electric starter and the other one is the gear reduction starter. Between the two, the electric starter is the widely used. That’s because the electric starter is used in gasoline or diesel engines. Modern starters use either magnet or electric motor current. Both types has relay or solenoid attached to it. The current which is from the battery passes to the solenoid to push out the pinion. The pinion then combines with the ring gear, powering the engine.
Problems can occur with the pinion when either the driver does not release the key soon after the engine has started, or there is a shortage somewhere in the system and the solenoid is not able to become disengaged. When this happens, the pinion will spin on its own and not with the drive shaft. To avoid worsening the problem, drivers should not attempt to start the vehicle right away. Drivers should wait for a few seconds before restarting the engine.
Chrysler is the company that modernized motor starters. It placed advancements to early starters so people will find it convenient to use. In 1960, Chrysler introduced the geartrain in the market. This new piece of equipment was installed between the drive shaft of the vehicle and the engine. Even though other manufacturers had produced starters with similar concepts before the 1960s, Chrysler was the first auto maker to create volumes of the unit.
Without a motor starter, a vehicle would not be able to travel far. It is an essential part of a vehicle that is instrumental in correct functioning and operation of the vehicle.